Verifone VX810 download needed
A message will appear on the display if an error occurs. In the table below, find the error message that appears on the terminal and try the solution. If the error message re-appears, contact the Moneris Merchant Service Centre for assistance.
PROBLEM & SOLUTION
Adjust Not Allow
You cannot perform a Correction (void) on a Contactless Purchase or Refund.
APP EXPIRED
The application on the contactless card is expired.
Request another form of payment.
BATCH FULL
The batch is full.
- If your account is configured for System Close, perform a Batch Reclaim now.
Batch Reclaim
Not Required
Press the green OK key to return to the transactions menu.
CARD BLOCKED
The contactless card was blocked.
Card Fail
Insert or Swipe
There was an error reading the contactless card.
Insert or swipe the same card or another card.
Card Fail
CARD NOT SUPPORTED
The type of card swiped on the terminal does not match the card type selected at the READY screen. For example, a Debit card was swiped during a Credit Pre-Authorization transaction or a Gift Card was swiped for a Loyalty Card transaction.
Try swiping the card again.
If this message reappears, press the red CANC ANNUL key to cancel the transaction and retry the transaction.
-OR-
Your merchant account with Moneris is not set up to accept the card type that was swiped.
CARD REMOVED
The chip card was removed before the end of the transaction.
Refer to "TRANS CANCELLED OK to Continue" in this table for more information.
CARD SWIPE ERROR
There is a problem with the magnetic stripe on the card that was swiped.
Try swiping the card again, this time more slowly or quickly, or from front of the terminal to the back.
If the message reappears:
- for credit card with stripe – key in the card number.
- for debit card with stripe or chip – request another form of payment.
